Fast booking car Mot Test and service Reading? The truth is, there will be elements of your car that you won’t be able to check yourself; however, there are parts that you can inspect and you should make sure that they are in good condition and full working order before going in for your MOT, otherwise you could fail on something minor and relatively simple to solve. How do you pass an MOT? The answer lies simply in looking after your car and checking that some fundamental things are in good working order before taking it to the garage.
The brake system of your car is one of the most important, which is why you need to pay attention to the brake pads. Most owner’s manuals recommend you change the pads every 20,000 miles. However, if you drive your car every day, and have to brake more often, you might have to replace them more often. People who live in the city and have to deal with a lot of traffic and stop more often should consider changing the pads more often. Replacing the brake pads is a fast and relatively inexpensive process.
We will consider Any Job And will Always Give you our Customer The Best Advice Possible To Save You Money Where We Can. Are You Going On Holiday, Get Your Car Checked By our Fully Qualified Technicians Before You decide to travel from the Reading Car Service Centre. Suitable for some high mileage vehicles needing frequent Car Engine Oil Change or low mileage vehicles needing only minor annual servicing. Oil and oil filters are changed, engine bay fluid levels are topped up and a visual brake system check and tyre report are carried out and completed. A vehicle health check and road test by a qualified technician are carried out.
Ignore the myth of the 100,000-mile tune-up. “It doesn’t exist,” states Principe. “Each vehicle has a specific tune-up schedule recommended by the manufacturer. The more you keep the systems clean, the better the vehicle will run.” Variations in climate and driving style also dictate the necessity for maintenance. Commuting in dusty desert conditions will quickly clog air filters, while driving short distances repeatedly can wear out the exhaust system, as moisture is never completely evacuated. Extremely hot and cold conditions require more attention paid to radiator fluid and engine oil. Read more info on Mot and service Reading.
Not every chip or crack on a windscreen will cost you an MoT certificate, as it’s all down to location. The details may seem complicated, but as a rule of thumb you can get away with chips smaller than 10mm in front of the driver. Any damage bigger than 10mm in front of the driver – and also in the glass area swept by the wipers – will be an MoT fail. Elsewhere on the glass, damage has to be larger than 40mm to constitute an MoT fail. Wiper blades must be in good condition – not perished or damaged – and clear the screen effectively. The washers must work too, and the MoT tester is within their rights to issue a fail if you haven’t topped up the washer bottle or unblocked dirty washer jets with a pin!
Probably the quickest and easiest test to do, and chances are that if this didn’t work, you’d already be aware of it and have had the fault fixed. So, as you’re doing your full pre-MOT checks, be sure to check the horn. The oil check is an important part of an MOT because without it, the garage will not be able to test emission levels. You can check this by taking a quick look under the bonnet. As you would when checking the brake fluid, do this test with the engine off and cool and the car parked on a flat, even surface. Locate the dipstick and pull it out, then wipe off any excess oil to ensure that you’re starting with a clean stick. Next, dip the dipstick back in and remove once more. You should see the oil sitting between the ‘min’ and ‘max’ marking on the dipstick. If you don’t, it’s time to top up your oil.
Cars are becoming ever more sophisticated. Unfortunately, this also means that there are more electronic components that could fail. Have you ever taken your car to a garage with a warning light on, only to find they can’t locate the problem? We use the latest diagnostic equipment to find the fault, and then we repair it. From ABS and airbag sensors, to engine management lights and air conditioning, we’re here to help you.
Headlights and indicators: front, rear, headlights (main beam and dipped), hazard lights and indicators. If any aren’t working, first check for broken bulbs and replace them. Brake lights: ask another person to check the rear brake lights come on when you press the brake pedal. Tyres: check all the tyres have at least the minimum legal tread depth of 1.6mm, or they’ll be marked as an MOT ‘fail’. This can easily be done with a 20p coin – see the diagram on the Tyre Safe website. Check for any damage such as splits in the tread, bulges or cuts in the sidewalls. Also check the tyre pressure is correct – the car’s manual will list the right pressure and they might also be on the sidewall of the tyre itself – and increase it at a petrol station if necessary. Read additional info on here.