Bending press machine factory 2022? World has been committed to the development and production of power press machines since it was established in 1953. More than 100 experienced engineers are working in the three R&D centers, one in Shanghai, one in factory and another one in Ningbo. See more information on bending press machine. We can provide installation service for all the sold out machines at customer factory. Small machines can be shipped assembled and some big machines must be shipped disassembled. That is why we provide installation service to our customer.
The imprint bending is the same as the bending of the bottomed die, except that the front end of the punch is processed to the required bending radius, and the gap between the punch and the die at th bottom of the stroke is smler than the material thickness. Since enough presure approximately 10 timesof fee bendig is applied to force the front end of the punchto contact the material, springback is basically avoided.
Synchronization system: The machine consists of a mechanical synchronization mechanism composed of torsion shats, wingarms, jont bearing, ec, with simple structure, stable ano reliable performance, and high synchronization accuracy. The mechanical stop is adjusted by the motor, and the numerical control system controls the value; Stopper mechanism: The stopper is driven by a motor, and the two screw rods are driven to move synchronously through a chain operation. The numerical controlsystem controls the size of the stopper.
As far as free bending is concerned, punch and die are procese at 85 or les (saler i better). When using this set of molds, pay attention to the ga beteen the male mold and the female mold at the bottom of the stroke, and the excessive bending that is sufficient to compensate for the springback and keep the material at about 90°. Generally, the springback angle of the free bending die on the new bending machine is s2, and the bending radis is equa to 0.156 times the opening distance of the die. For the bending of bottomed concave molds, the mold angle is generally 86 ~ 90°. At the bottom of the stroke, there should be a gap slightly larger than the thickness of the material between the male and female molds. The forming angle is improved because the bottomed die has a larger bending tonnage (about 4 times that of free bending), which reduces the stress that usually causes springback in the bending radius.
Modern and sophisticated materials are used in automotive engineering not only for the outer skin and structure of the actual car bodies but are also used in vehicle components such as the chassis, drive train, seats or trim parts. Auminum and steel are used for many components in the form of strips, sheets or plates, which are processed and formed in various manufacuring processes from semi-finished products to finished components. Even during these process steps, special demands are placed on the components. Due to the automated handing, good flatness and theloest possible degree of cut are very important for a machining procss itout comliations. Ifhese qualit criteria o not correspond to the defined specifications, there is no process reliability. Read additional details at https://www.pressmachine-world.com/.